Reset to Factory Default – Orbit Irrigation B-hyve Help. To reset your timer back to factory settings: Turn the timer to the OFF position by rotating the dial. Open the front panel and press the reset button for 10 seconds.
Why is my orbit Sprinkler not working?
There are various issues that may your Orbit sprinkler timer not work. It could range from a bad connection to a defective timer. Check the connection to the docking port to make sure your timer is plugged in properly. If the problem persists, remove the timer and reinsert it into the docking port.
Where is reset button on orbit?
Orbit Sprinkler Timer Instructions
- Push the “Reset” button (located in the bottom-right corner) to clear all previously programmed data if you’re programming the Orbit sprinkler timer for the first time.
- Twist the dial to “Time/Date” to set the date.
How do you manually start an orbit sprinkler system?
How do you manually start an orbit sprinkler system? From the Timer Box Turn the dial to the “Auto” position and press the ” Manual ” key to test the valves on Easy Dial and Easy Set Orbit timers.
How do I Reset my orbit irrigation timer?
Reset to Factory Default – Orbit Irrigation B-hyve Help. To reset your timer back to factory settings: Turn the timer to the OFF position by rotating the dial. Open the front swing panel and press and hold the reset button for 10-12 seconds.
How to set orbit easy-set logic timer?
Go through all the zones connected to your sprinklers, setting them to run for 1 minute. Rotate the dial to “How Often” and press the “right arrow” button until “INT” flashes along the bottom and press the “up” button to set it to “every 1 days”. “Int” means interval. You can adjust this for other options later.
How do you set the run time on orbit?
Use the up/down arrow buttons to alter the month and day to the current date. Rotate the center dial to “Run Time” and choose program A (upper right small button on the box toggles through programs A, B, and C”). The first zone showing should be #1. Set this to 1 minute by pressing the up arrow button on the right side of the panel face.
