Turn the power to your fan off for 5-10 seconds and then back on using the wall switch. Quickly press the ‘PAIR’ button on the back of the remote control. This step should be done within three minutes of restoring power to the fan. Your fan should turn on low speed indicating the pairing was successful.
How do you reset a Hunter fan remote?
How do I reset my fan remote? Reset the fan remote If you want to reset the remote: Turn off the ceiling fan using the remote. Wait for about 30 seconds before turning the power on. Within those seconds, hold down the off button on the fan for about ten seconds.
Why is my Hunter fan remote not working?
Perhaps the most common cause for a ceiling fan remotes not working is either a lack of batteries or dead batteries. If your remote control has an indicator light, check to see if it comes on. Open the remote control battery cover. Make sure it has batteries and that they’re in the correct position.
Why did my ceiling fan stopped working but light still works?
If your ceiling fan stopped working but the light still works, check for a humming sound. This could be indicative of a blown motor capacitor, which is often caused by overheating. While inspecting the motor housing, look for a small black box connected to the pull cord.
How do you program a hunter ceiling fan?
How to Program Hunter Ceiling Fans. Go to your circuit breaker or fuse box, and turn off the power to the fan you will be programming. Turn the fan’s remote control over, and remove the battery compartment cover. Match the DIP switches inside the remote’s battery compartment with the DIP switches on the fan’s receiver unit.
How do you pair a ceiling fan remote?
Turn the power to your fan off, wait one minute, and then try again. Turn the power to your fan off for 5-10 seconds and then back on using the wall switch. Quickly press the ‘PAIR’ button on the back of the remote control. This step should be done within three minutes of restoring power to the fan.
Why are my Hunter ceiling fan remotes not working?
Eventually, the batteries will just die and then you will not have any control via the remote any further. Always check the batteries as a first step anytime you are having problems with your remote. The dipswitches is what controls the frequency of the remote.
How do you reset a Hampton bay ceiling fan?
Reset the fan remote If you want to reset the remote: Turn off the ceiling fan using the remote. Wait for about 30 seconds before turning the power on. Within those seconds, hold down the off button on the fan for about ten seconds.
